A 68 kg crate is dragged across a floor by pulling on a rope attached to the
Question:
A 68 kg crate is dragged across a floor by pulling on a rope attached to the crate and inclined 15o above the horizontal.
(a) If the coefficient of static friction is 0.50, what minimum force magnitude is required from the rope to start the crate moving?
(b) If µk = 0.35, what is the magnitude of the initial acceleration of the crate?
Step by Step Answer:
a The freebody diagram for the crate is shown on the right 7 is the tension force of the rope on the ...View the full answer
Fundamentals of Physics
ISBN: 978-0471758013
8th Extended edition
Authors: Jearl Walker, Halliday Resnick
Related Video
Static friction and kinetic friction are two types of friction that occur when two objects are in contact with each other. Static friction is the force that must be overcome to initiate motion between two surfaces that are in contact with each other but are not moving relative to each other. It is caused by the interlocking of rough surfaces at the microscopic level, and it increases as the force pushing the surfaces together increases. Once motion between the surfaces starts, the static friction is no longer present. Kinetic friction, also known as sliding friction, is the force that opposes the motion of two surfaces that are in contact with each other and are moving relative to each other. It is caused by the rubbing of the surfaces against each other and the resistance of the molecules in the surfaces to being moved. Kinetic friction is generally less than static friction, but it can still be a significant force, especially at high speeds. Both static and kinetic friction can be quantified using a coefficient of friction, which is a dimensionless number that represents the ratio of the frictional force between two surfaces to the normal force (the force perpendicular to the surfaces). The coefficient of static friction is typically greater than the coefficient of kinetic friction for a given pair of surfaces, because it takes more force to overcome the interlocking of the surfaces at rest than to maintain motion once it has started.
Students also viewed these Mechanics questions
-
If the coefficient of static friction between your coffee cup and the horizontal dashboard of your car is s = 0.800, how fast can you drive on a horizontal roadway around a right turn of radius 30.0...
-
If the coefficient of static friction between a table and a uniform massive rope is x, what fraction of the rope can hang over the edge of the table without the rope sliding?
-
If the coefficient of static friction between a car's tires and the pavement is 0.65, calculate the minimum torque that must be applied to the 66-cm-diameter tire of a 1080-kg automobile in order to...
-
Find the magnitude and direction of the electric field strength at the point P due to the point charges at A and B as shown in the Figure 1. (k = 9 x 10 Nm/C) +2 C 10 cm A 10 cm Figure 1 B -8 C (5...
-
Next year, California Cement Company will increase its Plant, Property, and Equipment (PPE) by $6,000,000 with a plant expansion. The inventories will grow by 80%, accounts receivable will grow by...
-
What is marginal benefit? How is it measured?
-
Does a correlation between hours of work and nonlabor income measure the income effect?
-
The adjusted trial balance of Hanlon Corporation at December 31, 2012, includes the following accounts: Retained Earnings $17,200; Dividends $6,000; Service Revenue $32,000; Salaries and Wages...
-
comments about these post? 1. The bullwhip effect is a word used to explain a situation in supply chain management where minor consumer demand changes can cause intense fluctuations in demand...
-
Magnesium silicate, Mg2SiO4, forms in the olivine crystal structure that consists of an HCP arrangement of O2- ions. (a) Which type of interstitial site will the Mg2+ ions occupy? Why? (b) Which type...
-
Figure 6-23 shows the cross section of a road cut into the side of a mountain. The solid line AA' represents a weak bedding plane along which sliding is possible. Block B directly above the highway...
-
Figure shows an initially stationary block of mass m on a floor. A force of magnitude 0.500mg is then applied at upward angle = 20 o . What is the magnitude of the acceleration of the block across...
-
Figure 15P-2 shows the monopolistically competitive market for smartphones. a. Is this producer earning positive or negative profits in the short run? b. In the long run, will economic profits...
-
An electron travels to the right at \(2.5 \times 10^{6} \mathrm{~m} / \mathrm{s}\) between two large, flat sheets that are parallel to each other and to the electron's line of motion. A current per...
-
A parallel-plate capacitor with air between its plates can hold \(6 \mathrm{pC}\) of charge per volt of potential difference across its plates. When a barium titanate dielectric slab completely fills...
-
Air enters the diffuser of an aircraft jet engine at a static pressure of $20 \mathrm{kPa}$ and static temperature $217 \mathrm{~K}$, and a Mach number of 0.9. The air leaves the diffuser with a...
-
Let Y Y be an n m n m array of real-valued random variables with zero mean and covariance matrix for some non-negative coefficients 2 0 , , 2 3 0 2 , , 3 2 . Show that the covariance matrix...
-
Representing a transmission line by the two-port network, in terms of A B C D A B C D parameters, (a) express V S V S , the sending-end voltage, in terms of V R V R , the receiving-end voltage, and I...
-
\(x_{1}=30, n_{1}=225, x_{2}=40, n_{2}=317,95 \%\) confidence Construct a confidence interval for \(p_{1}-p_{2}\) at the given level of confidence.
-
Whats the difference between an ordinary annuity and an annuity due? What type of annuity is shown below? How would you change the time line to show the other type of annuity?
-
Calculate the mass of the Sun based on data for Earths orbit and compare the value obtained with the Suns actual mass.
-
Three-lens systems. In Figure, stick figure O (the object) stands on the common central axis of three thin, symmetric lenses, which are mounted in the boxed regions. Lens 1 is mounted within the...
-
Three-lens systems. In Figure, stick figure O (the object) stands on the common central axis of three thin, symmetric lenses, which are mounted in the boxed regions. Lens 1 is mounted within the...
-
Three-lens systems. In Figure, stick figure O (the object) stands on the common central axis of three thin, symmetric lenses, which are mounted in the boxed regions. Lens 1 is mounted within the...
-
1. What is team velocity and how does it impact the development of a project? 2. What is the purpose of SCRUM meetings, and how can one best prepare to take part in it?
-
Lew's market invested in project that returned 16.67 percent during a period when inflation averaged 3.26 percent. What real rate of return did Lew earn on its project? Explain in Detail?
-
Identify the major topographic features of ocean basins, and state how they are related to plate tectonics. The Himalaya and the Alps are said to be the graveyards of ancient oceans. Why?
Study smarter with the SolutionInn App