# Question: a A square loop of wire with sides of length

(a) A square loop of wire with sides of length 40 cm is in a uniform magnetic field perpendicular to its area. If the field’s strength is initially 100 mT and it decays to zero in 0.010 s, what is the magnitude of the average emf induced in the loop?

(b) What would be the average emf if the sides of the loop were only 20 cm?

(b) What would be the average emf if the sides of the loop were only 20 cm?

**View Solution:**## Answer to relevant Questions

The magnetic flux through one loop of wire is reduced from 0.35Wb to 0.15Wb in 0.20 s. The average induced current in the coil is 10 A. (a) Can you determine the area of the loop from the data given? Explain. (b) Find the ...For each of the following cases for an RLC circuit, does the resonance frequency increase, decrease, or stay the same? If it changes tell by what factor. (a) Only the capacitance is changed—it is quadrupled. (b) Only the ...What are the peak and rms voltages of a 120-V ac line and a 240-V ac line? A single 2.0-μF capacitor is connected across the terminals of a 60-Hz voltage source, and a current of 2.0 mA is measured on an ac ammeter. What is the capacitive reactance of the capacitor? With a single 150-mH inductor in a circuit with a 60-Hz voltage source, a current of 1.6 A is measured on an ac ammeter. (a) What is the rms voltage of the source? (b) What is the phase angle between the current and that ...Post your question