# Question: A capacitor in a single loop RC circuit is charged to

A capacitor in a single-loop RC circuit is charged to of its final voltage in 1.5 s. Find

(a) The time constant for the circuit and

(b) The percentage of the circuit’s final voltage after 3.5 s.

(a) The time constant for the circuit and

(b) The percentage of the circuit’s final voltage after 3.5 s.

**View Solution:**## Answer to relevant Questions

In Fig. 18.11b, the switch is closed at t = 0, and the capacitor begins to charge. What is the voltage across the resistor and across the capacitor, expressed as fractions of Vo (to two significant figures), (a) Just after ...A series RC circuit with C = 40-μF and R = 6.0Ω has a 24-V source in it. With the capacitor initially uncharged, an open switch in the circuit is closed. (a) What is the volt-age across the resistor immediately ...A galvanometer with a full-scale sensitivity of 600 μA and a coil resistance of 50-Ω is to be used to build an ammeter designed to read 5.0 A at full scale. What is the required shunt resistance? Three resistors with values of 5.0-Ω, 10-Ω, and 15-Ω are connected in series in a circuit with a 9.0-V battery. (a) What is the total equivalent resistance? (b) What is the current in each resistor? (c) At what rate ...An air-filled parallel plate capacitor is being used in an electrical circuits laboratory. The plates are separated by 1.50 mm and each has a diameter of 15.0 cm. (a) What is the capacitance of this plate arrangement? (b) ...Post your question