# Question: A coil with a resistance of and an inductance of

A coil with a resistance of and an inductance of 0.15 H is connected to a 120-V, 60-Hz source.

(a) Is the phase angle of this circuit (1) positive, (2) zero, or (3) negative? Why?

(b) What is the phase angle of the circuit?

(c) How much rms current is in the circuit?

(d) What is the average power delivered to the circuit?

(a) Is the phase angle of this circuit (1) positive, (2) zero, or (3) negative? Why?

(b) What is the phase angle of the circuit?

(c) How much rms current is in the circuit?

(d) What is the average power delivered to the circuit?

## Answer to relevant Questions

A small welding machine uses a voltage source of 120 V at 60 Hz. When the source is operating, it requires 1200 W of power, and the power factor is 0.75. (a) What is the machine’s impedance? (b) Find the rms current in ...A series RLC circuit with a resistance of 400-Ω has capacitive and inductive reactances of 300-Ω and 500-Ω, respectively. (a) What is the power factor of the circuit? (b) If the circuit operates at 60 Hz, what ...The circuit in Fig. 21.18a is called a low-pass filter because a large current and voltage (and thus a lot of power) are delivered to the load resistor (RL) only by a low-frequency source. The circuit in Fig. 21.18b is ...If glass is dispersive, why don’t we normally see a spectrum of colors when sunlight passes through a glass window? Explain. (Are the speeds of each color of light the same in the glass?) Light passes from a crown glass container into water. (a) Will the angle of refraction be (1) greater than, (2) equal to, or (3) less than the angle of incidence? Explain. (b) If the angle of refraction is 20o, what is the ...Post your question