# Question: A Estimate the potential capability of the process b Estimate the

a. Estimate the potential capability of the process.

b. Estimate the actual process capability.

c. How much improvement could be made in process performance if the mean could be centered at the nominal value?

b. Estimate the actual process capability.

c. How much improvement could be made in process performance if the mean could be centered at the nominal value?

**View Solution:**## Answer to relevant Questions

a. Estimate the potential capability. b. Estimate the actual capability. c. How much could process fallout be reduced by shifting the mean to the nominal dimension? Assume that the quality characteristic is normally ...An electric utility tracks the response time to customer reported outages. The data in Table 5E.17are a random sample of 40 of the response times (in minutes) for one operating division of this utility during a single ...The data in Table 6E.1 give the number of nonconforming bearing and seal assemblies in samples of size 100. Construct a fraction nonconforming control chart for these data. If any points plot out of control, assume that ...The number of nonconformities found on final inspection of a tape deck is shown in Table 6E.11. Can you conclude that the process is in statistical control? What center line and control limits would you recommend for ...A control chart for nonconformities is to be established in conjunction with the final inspection of a radio. The inspection unit is to be a group of ten radios. The average number of nonconformities per radio has, in the ...Post your question