a. Estimate the process standard deviation.
b. Construct a CUSUM chart for this process using standardized values of h = 5 and k = 1/2.
Answer to relevant QuestionsIn exercise In exercise The height of the disk used in a computer disk drive assembly is a critical quality characteristic. Table 5E.15 gives the heights (in mm) of 25 disks randomly selected from the manufacturing process. Prepare a normal ...A molding process uses a five-cavity mold for a part used in an automotive assembly. The wall thickness of the part is the critical quality characteristic. It has been suggested to use and R charts to monitor this process, ...The number of nonconformities found on final inspection of a tape deck is shown in Table 6E.11. Can you conclude that the process is in statistical control? What center line and control limits would you recommend for ...
Post your question