# Question

A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 4.00 cm2 and a large one of cross-sectional area 250 cm2.

(a) If this lift is designed to raise a 3500-kg car, what minimum force must be applied to the small piston?

(b) If the force is applied through compressed air, what must be the minimum air pressure applied to the small piston?

(a) If this lift is designed to raise a 3500-kg car, what minimum force must be applied to the small piston?

(b) If the force is applied through compressed air, what must be the minimum air pressure applied to the small piston?

## Answer to relevant Questions

A 5.0-m-long rod is stretched 0.10 m by a force. What is the strain in the rod? A rectangular boat, as illustrated in Fig. 9.39, is over-loaded such that the water level is just 1.0 cm below the top of the boat. What is the combined mass of the people and the boat? (a) Given a piece of metal with a light string attached, a scale, and a container of water in which the piece of metal can be submersed, how could you find the volume of the piece without using the variation in the water ...(a) If the radius of a pipe narrows to half of its original size, will the flow speed in the narrow section (1) increase by a factor of 2, (2) increase by a factor of 4, (3) decrease by a factor of 2, or (4) decrease by a ...Water flows at a rate of 25 L/min through a horizontal 7.0-cm-diameter pipe under a pressure of 6.0 Pa. At one point, calcium deposits reduce the cross-sectional area of the pipe to 30 cm2. What is the pressure at this ...Post your question

0