# Question: A measurement systems experiment involving 20 parts three operators and

A measurement systems experiment involving 20 parts, three operators, and two measurements per part is shown in Table 8E.12.

(a) Estimate the repeatability and reproducibility of the gauge

(b) What is the estimate of total gauge variability?

(c) If the product specifications are at LSL = 6 and USL = 60, what can you say about gauge capability?

(a) Estimate the repeatability and reproducibility of the gauge

(b) What is the estimate of total gauge variability?

(c) If the product specifications are at LSL = 6 and USL = 60, what can you say about gauge capability?

**View Solution:**## Answer to relevant Questions

Reconsider the gauge R&R experiment in Exercise 8.34. Calculate the quantities SNR and DR for this gauge. Discuss what information these measures provide about the capability of the gauge. Perform a process capability analysis using x and R charts for the data in Exercise 6.7. Sample of 25 measurements on a normally distributed quality characteristic has a mean of 85 and a standard deviation of 1. Using a confidence probability of 0.95, find a value such that 90% of the future measurements on this ...A process is in statistical control with x = 199 and R = 3.5. The control chart uses a sample size of n= 4. Specifications are at 200 ± 8. The quality characteristic is normally distributed. USL = 200 + 8 = 208; LSL = 200 ...Consider the “minute clinic” waiting time data in Exercise 6.66. These data may not be normally distributed. Set up a EWMA control chart using = 0.1 for monitoring this process. Does the process seem to be in ...Post your question