Question: A molding process uses a five cavity mold for a part
A molding process uses a five-cavity mold for a part used in an automotive assembly. The wall thickness of the part is the critical quality characteristic. It has been suggested to use X and R charts to monitor this process, and to use as the subgroup or sample all five parts that result from a single “shot” of the machine. What do you think of this sampling strategy? What impact does it have on the ability of the charts to detect assignable causes?
Answer to relevant QuestionsA manufacturing process produces 500 parts per hour. A sample part is selected about every half hour, and after five parts are obtained, the average of these five measurements is plotted on an x control chart. (a) Is this an ...Apply the Western Electric rules to the control chart in Exercise 5.17. Are any of the criteria for declaring the process out of control satisfied? Develop a flowchart for the process that you follow every morning from the time you awake until you arrive at your workplace (or school). Identify the value-added and non-value-added activities. The fill volume of soft-drink beverage bottles is an important quality characteristic. The colume is measured (approximately) by placing a gauge over the crown and comparing the height of the liquid in the neck of the bottle ...A company manufacturing oil seals wants to establish control charts on the process. There are 25 preliminary samples of size 5 on the internal diameter of the seal. The summary data (in mm) are as follows: and x R (a) Find ...
Post your question