# Question: A process is controlled with a fraction nonconforming control chart

A process is controlled with a fraction nonconforming control chart with three-sigma limits, n = 100, UCL = 0.161, center line = 0.080, and LCL = 0.

(a) Find the equivalent control chart for the number nonconforming.

(b) Use the Poisson approximation to the binomial to find the probability of a type I error.

(c) Use the correct approximation to find the probability of a type II error if the process fraction nonconforming shifts to 0.2.

(d) What is the probability of detecting the shift in part (c) by at most the fourth sample after the shift?

(a) Find the equivalent control chart for the number nonconforming.

(b) Use the Poisson approximation to the binomial to find the probability of a type I error.

(c) Use the correct approximation to find the probability of a type II error if the process fraction nonconforming shifts to 0.2.

(d) What is the probability of detecting the shift in part (c) by at most the fourth sample after the shift?

## Answer to relevant Questions

A process is being controlled with a fraction nonconforming control chart. The process average has been shown to be 0.07. Three-sigma control limits are used, and the procedure calls for taking daily samples of 400 items. ...A fraction nonconforming control chart with center line 0.10, UCL = 0.19, and LCL = 0.01 is used to control a process. (a) If three-sigma limits are used, find the sample size for the control chart. (b) Use the Poisson ...A process has an in-control fraction nonconforming of p = 0.02. What sample size would be required for the fraction nonconforming control chart if it is desired to have a probability of at least one nonconforming unit in the ...A fraction nonconforming control chart is to be established with a center line of 0.01 and two-sigma control limits. (a) How large should the sample size be if the lower control limit is to be nonzero? (b) How large should ...The number of nonconformities found on final inspection of a tape deck is shown in Table 7E.14. Can you conclude that the process is in statistical control? What center line and control limits would you recommend for ...Post your question