# Question: A process is to be monitored with standard values

A process is to be monitored with standard values µ = 10 and σ= 2.5. The sample size is n = 2.

(a) Find the center line and control limits for the x chart.

b) Find the center line and control limits for the R chart.

(c) Find the center line and control limits for the s chart.

(a) Find the center line and control limits for the x chart.

b) Find the center line and control limits for the R chart.

(c) Find the center line and control limits for the s chart.

## Answer to relevant Questions

Samples f n= 5 units are taken from a process every hour. The x and R values for a particular quality characteristic are determined. After 25 sample have been collected, we calculate x =20 and R = 4.56. (a) What are the ...Control charts for x and R are to be established to control the tensile strength of a metal part. Assume that tensile strength is normally distributed. Thirty samples of size n= 6 parts are collected over a period of time ...Two parts are assembled as shown in Figure 6.28. Assume that the dimensions x and y are normally distributed with means x and y and standard deviations x and y, respectively. The parts are produced on different ...Statistical monitoring of a quality characteristic uses both an x and s chart. The charts are to be based on the standard values m = 200 and sx = 10, with n = 4. (a) Find three-sigma control limits for the s chart. (b) Find ...Components used in a cellular telephone are manufactured with nominal dimension of 0.3 mm and lower and upper specification limits of 0.295 mm and 0.305 mm respectively. The x and R control charts for this process are based ...Post your question