# Question

A product is packaged by filling a container completely full. This container is shaped as shown in the figure. The process that produces these containers is examined, and the following information collected on the three critical dimensions:

## Answer to relevant Questions

A rectangular piece of metal of width W and length L is cut from a plate of thickness T. If W, L, and T are independent random variables with means and standard deviations as given here and the density of the metal is 0.08 ...An assembly of two parts is formed by fitting a shaft into a bearing. It is known that the inside diameters of bearings are normally distributed with mean 2.010 cm and standard deviation 0.002 cm, and that the outside ...Estimate process capability using the x and R charts for the power supply voltage data in Exercise 6.8 (note that early printings of the 7th edition indicate Exercise 6.2). If specifications are at 350 ± 50 V, calculate Cp, ...Consider the loan processing cycle time data in Exercise 8.15. Set up a CUSUM chart for monitoring this process. Does the process seem to be in statistical control? x p50 18.05; p84 20.53; p84 p50 ...Rework Exercise 9.1 using a standardized CUSUM. Exercise 9.1Post your question

0