# Question: A set of jumper cables used to start a car

A set of jumper cables used to start a car from another car’s battery is connected to the terminals of both batteries. If 15 A of current exists in the cables during the starting procedure and the cables are parallel and 15 cm apart,

(a) Do the wires repel or attract? Explain.

(b) What is the magnetic field strength that each wire produces at the location of the other?

(c) What is the force per unit length on the cables? Include an explanation of whether the wires repel or attract one another.

(a) Do the wires repel or attract? Explain.

(b) What is the magnetic field strength that each wire produces at the location of the other?

(c) What is the force per unit length on the cables? Include an explanation of whether the wires repel or attract one another.

## Relevant Questions

Two long, straight, parallel wires carry the same current in the same direction. (a) Use both the right-hand source and force rules to determine whether the forces on the wires are (1) attractive or (2) repulsive. (b) If ...(a) Exiting from a small linear accelerator near Washington D. C., a proton is moving parallel to the ground. What should the direction(s) of its velocity be in order to maximize the upward component of the Earth’s ...A student has a bright idea for a generator that apparently generates electric energy without a corresponding loss of energy somewhere else. His suggested arrangement is shown in Fig. 20.31. The magnet is initially pulled ...By using the appropriate SI units, show that the units on both sides of Eq. 20.2 (Faraday’s law) are the same. A fixed coil of wire with 10 turns and an area of 0.055m2 is placed in a perpendicular magnetic field. This field oscillates in direction and magnitude at a frequency of 10 Hz and has a maximum value of 0.12 T, (a) What is ...Post your question