Question: An abrasive cutoff wheel has a diameter of 6 in is 1 16
An abrasive cutoff wheel has a diameter of 6 in, is 1/16 in thick, and has a 1-in bore. It weighs 6 oz and is designed to run at 10 000 rev/min. If the material is isotropic and ν = 0.20, find the maximum shear stress at the design speed.
Answer to relevant QuestionsA rotary lawn-mower blade rotates at 3000 rev/min. The steel blade has a uniform cross section 1/8 in thick by 1 ¼ in wide, and has a ½ -in-diameter hole in the center as shown in the figure. Estimate the nominal ...The steel eyebolt shown in the figure is loaded with a force F of 100 lbf. The bolt is formed of ¼ -in-diameter wire to a 3/8 -in radius in the eye and at the shank. Estimate the stresses at the inner and outer surfaces at ...Two carbon steel balls, each 25 mm in diameter, are pressed together by a force F. In terms of the force F, find the maximum values of the principal stress, and the maximum shear stress, in MPa.An engineer is forced by geometric considerations to apply the torque on the spring of Prob. 4–3 at the location x = 0.2l. For a uniform-diameter spring, this would cause the long leg of the span to be underutilized when ...A simply supported beam loaded by two forces is shown in the figure. Select a pair of structural steel channels mounted back to back to support the loads in such a way that the deflection at midspan will not exceed 1/16 in ...
Post your question