Question: An analyst has timed a metal cutting operation for 50
An analyst has timed a metal- cutting operation for 50 cycles. The average time per cycle was 10.40 minutes, and the standard deviation was 1.20 minutes for a worker with a performance rating of 125 percent. Assume an allowance of 16 percent of job time. Find the standard time for this operation.
Answer to relevant QuestionsA job was timed for 60 cycles and had an average of 1.2 minutes per piece. The performance rating was 95 percent, and workday allowances are 10 percent. Determine each of the following: a. Observed time. b. Normal time. c. ...A worker-machine operation was found to involve 3.3 minutes of machine time per cycle in the course of 40 cycles of stopwatch study. The worker’s time averaged 1.9 minutes per cycle, and the worker was given a rating of ...An analyst made the following observations about whether customer service representatives were busy (B) or idle (I): a. What is the percentage of idle time? b. Given these results, how many observations would be needed to ...What factors might cause a learning curve to tip up toward the end of a job?The labor cost to produce a certain item is $ 8.50 per hour. Job setup costs $ 50 and material costs are $ 20 per unit. The item can be purchased for $ 88.50 per unit. The learning rate is 90 percent. Overhead is charged at ...
Post your question