# Question

An EWMA control chart uses = 0.4. How wide will the limits be on the Shewhart control chart, expressed as a multiple of the width of the steady-state EWMA limits?

For EWMA, steady-state limits are

For EWMA, steady-state limits are

## Answer to relevant Questions

Consider the valve failure data in Example 7.6. Set up a CUSUM chart for monitoring the time between events using the transformed variable approach illustrated in that example. Use standardized values of h = 5 and k = ½. Reconsider the data in Exercise 9.4. Suppose the data there represent observations taken immediately after a process adjustment that was intended to reset the process to a target of µ0 = 8.00. Set up and apply an FIR CUSUM ...Specifications on a bearing diameter are established at 8.0 ± 0.01 cm. Samples of size n = 8 are used, and a control chart for s shows statistical control, with the best current estimate of the population standard deviation ...Use the data in Table 10E.2 to set up appropriate short-run x and R charts, assuming that the standard deviations of the measured characteristic for each part type are not the same. The nominal dimensions for each part are ...(a) Discuss the use of the moving range method to estimate the process standard deviation when the data are positively autocorrleated. (b) Discuss the use of the sample variance s2 with positively autocorrelated data. ...Post your question

0