# Question

An inspector counts the surface-finish defects in dishwashers. A random sample of five dishwashers contains three such defects. Is there reason to conclude that the mean occurrence rate of surface-finish defects per dishwasher exceeds 0.5? Use the results of part (a) of Exercise 4.32 and assume that a = 0.05.

## Answer to relevant Questions

An in-line tester is used to evaluate the electrical function of printed circuit boards. This machine counts the number of defects observed on each board. A random sample of 1,000 boards contains a total of 688 defects. Is ...Suppose that you are testing the following hypotheses where the variance is unknown: H0 : 100 H1 : 100 The sample size is n = 20. Find bounds on the P-value for the following values of the test statistic. (a) ...The brake horsepower developed by an automobile engine on a dynamometer is thought to be a function of the engine speed in revolutions per minute (rpm), the road octane number of the fuel, and the engine compression. An ...Suppose that you are testing H0 : 1 2 versus H1 : 1 2 with a n1 = n2 = 15. Use the table of the t distribution percentage points to find lower and upper bounds on the P-value for the following observed ...The inside diameters of bearings used in an aircraft landing gear assembly are known to have a standard deviation of = 0.002 cm. A random sample of 15 bearings has an average inside diameter of 8.2535 cm. (a) Test the ...Post your question

0