# Question: An x chart is to be designed for a quality

An x chart is to be designed for a quality characteristic assumed to be normal with a standard of 4.

Specifications on the quality characteristic are 800 ± 20. The control chart is to be designed so that if the fraction nonconforming is 1%, the probability of a point falling inside the control limits will be 0.90. The sample size is n = 4. What are the control limits and center line for the chart?

Specifications on the quality characteristic are 800 ± 20. The control chart is to be designed so that if the fraction nonconforming is 1%, the probability of a point falling inside the control limits will be 0.90. The sample size is n = 4. What are the control limits and center line for the chart?

**View Solution:**## Answer to relevant Questions

A normally distributed quality characteristic is controlled by x and R charts having the following parameters (n = 4, both charts are in control): (a) What is the estimated standard deviation of the quality characteristic ...Use the data in Table 10E.2 to set up appropriate short-run x and R charts, assuming that the standard deviations of the measured characteristic for each part type are not the same. The nominal dimensions for each part are ...Consider the temperature data in exercise 10.24. Set up an EWMA control chart on the residuals from the model you fit to the data in part (c) of that exercise. Compare it to the individuals chart you constructed using the ...An x chart is used to maintain current control of a process. The cost parameters are a1 = $2, a2 = $0.50, a3 = $50, a′3 = $75, and a4 = $200. A single assignable cause of magnitude δ = 1 occurs, and the duration of the ...Suppose that we have p= 4 quality characteristics, and in correlation form all four variables have variance unity and all pairwise correlation coefficients are 0.7. The in-control value of the process mean vector is u’ = ...Post your question