# Question: An x chart is used to control the mean of

An x chart is used to control the mean of a normally distributed quality characteristic. It is known that σ = 6.0 and n = 4. The center line = 200, UCL = 209, and LCL = 191. If the process mean shifts to 188, find the probability that this shift is detect on the first subsequent sample.

## Answer to relevant Questions

A critical dimension of a machined part has specifications 100 + –10. Control chart analysis indicates tht the process is in control with x=104 and R = 9.30. The control charts use samples of size n = 5. If we assume that ...Suppose that following the construction of the x and R control charts in Exercise 6.34, the process engineers decided to change the subgroup size to n = 2. Table 6E.16 contains 10 new subgroups of thickness data. Plot this ...Specifications on a cigar lighter detent are 0.3220 and 0.3200 in. Samples of size 5 are taken every 45 minutes with the results shown in Table 6E.18 (measured as deviations from 0.3210 in 0.0001 in.). (a) Set up an R chart ...A hospital emergency department is monitoring the time required to admit a patient using x and R charts. Table 6E.1 presents summary data for 20 subgroups of two patients each (time is in minutes). A normally distributed quality characteristic is monitored through use of an Both charts exhibit control. (a) What is the estimated standard deviation of the process? (b) Suppose an s chart were to be substituted for the R ...Post your question