Question: Assume that we want to use the sample data from
Assume that we want to use the sample data from Exercise 1 to test the claim that the sample is from a population with a standard deviation less than 1.8 min; we will use a 0.05 significance level to test that claim. If we want to use the confidence interval method of testing hypotheses, what level of confidence should be used for the confidence interval? Will the conclusion based on the confidence interval be the same as the conclusion based on a hypothesis test that uses the P-value method or the critical value method?
Answer to relevant QuestionsFor the sample data from Exercise 1, we have s = 0.5 and we want to use that sample to test the claim that the sample is from a population with a standard deviation less than 1.8 min (as it was in the past with multiple ...A simple random sample of 25 filtered 100-mm cigarettes is obtained, and the tar content of each cigarette is measured. The sample has a standard deviation of 3.7 mg (based on Data Set 10 in Appendix B). Use a 0.05 ...Data Set 21 in Appendix B includes a simple random sample of “wheat” pennies. U.S. Mint specifications now use a standard deviation of 0.0230 g for weights of pennies. Use a 0.01 significance level to test the claim that ...Listed below are measured amounts of lead (in micrograms per cubic meter, or mg/m3, in the air. The Environmental Protection Agency has established an air quality standard for lead of 1.5 mg/m3. The measurements shown below ...The sitting height (from seat to top of head) of drivers must be considered in the design of a new car model. Men have sitting heights that are normally distributed with a mean of 36.0 in. and a standard deviation of 1.4 in. ...
Post your question