# Question: A bolted joint is to have a grip consisting

A bolted joint is to have a grip consisting of two 14-mm steel plates and one 14R metric plain washer to fit under the head of the M14 ?2 hex-head bolt, 50 mm long.

(a) What is the length of the thread LT for this diameter metric coarse-pitch series bolt?

(b) What is the length of the grip l?

(c) What is the height H of the nut?

(d) Is the bolt long enough? If not, round to the next larger preferred length (Table A–17).

(e) What is the length of the shank and the threaded portions of the bolt within the grip? These lengths are needed in order to estimate bolt spring rate kb

(a) What is the length of the thread LT for this diameter metric coarse-pitch series bolt?

(b) What is the length of the grip l?

(c) What is the height H of the nut?

(d) Is the bolt long enough? If not, round to the next larger preferred length (Table A–17).

(e) What is the length of the shank and the threaded portions of the bolt within the grip? These lengths are needed in order to estimate bolt spring rate kb

**View Solution:**## Answer to relevant Questions

A blanking disk 0.875 in thick is to be fastened to a spool whose flange is 1 in thick, using eight ½ in-13 X 1.75 in hex-head cap screws. (a) What is the length of threads LT for this cap screw? (b) What is the effective ...Take Eq. (8–22) and express km /(Ed) as a function of l/d, then compare with Eq. (8–23) for d / l = 0.5.In addition to the data of Prob. 8–24, the dimensions of the cylinder are A = 3.5 in and an effective seal diameter of 4.25 in. The internal static pressure is 1500 psi. The outside diameter of the head is C = 8 in. The ...The section of the sealed joint shown in the figure is loaded by a repeated force P = 6 kip. The members have E = 16 Mpsi. All bolts have been carefully preloaded to Fi = 25 kip eachA beam is made up by bolting together two cold-drawn bars of AISI 1018 steel as a lap joint, as shown in the figure. The bolts used are ISO 5.8. Ignoring any twisting, determine the factor of safety of the connectionPost your question