Question: A cast aluminum 195 T6 has an ultimate strength
A cast aluminum 195-T6 has an ultimate strength in tension of Sut = 36 kpsi and ultimate strength in compression of Suc = 35 kpsi, and it exhibits a true strain at fracture εf = 0.045. Choose and plot the failure locus and, for the static loading inducing the stresses at the critical locations of Prob. 5–9, plot the load lines and estimate the factors of safety analytically and graphically.
Answer to relevant QuestionsThe network shown is a current-to-voltage converter or transresistance amplifier. Find VO/is for this network. Determine the power dissipated in the 6-ohm resistor in the network shown. Determine the output voltage Vo of the summing op-amp circuit shown. By modern standards, the shaft design of Prob. 5–23 is poor because it is so long. Suppose it is redesigned by halving the length dimensions. Using the same material and design factor as in Prob. 5–23, find the new shaft ...In Prob. 5–31, the role of the screw was to induce the hoop tension that produces the clamping. The screw should be placed so that no moment is induced in the ring. Just where should the screw be located?
Post your question