# Question: Components used in a cellular telephone are manufactured with nominal

Components used in a cellular telephone are manufactured with nominal dimension of 0.3 mm and lower and upper specification limits of 0.295 mm and 0.305 mm respectively. The x and R control charts for this process are based on subgroups of size 3 and they exhibit statistical control, with the center line on the x at 0.3015 mm and the center line on the R chart at 0.00154 mm.

(a) Estimate the mean and standard deviation of this process.

(b) Suppose that parts below the lower specification limits can be reworked, but parts above the upper specification limit must be scrapped. Estimate the proportion of scrap and rework produced by this process.

(c) Suppose that the mean of this process can be reset by fairly simple adjustments. What

(a) Estimate the mean and standard deviation of this process.

(b) Suppose that parts below the lower specification limits can be reworked, but parts above the upper specification limit must be scrapped. Estimate the proportion of scrap and rework produced by this process.

(c) Suppose that the mean of this process can be reset by fairly simple adjustments. What

**View Solution:**## Answer to relevant Questions

The following x and s charts based on n = 4 have shown statistical control: (a) Estimate the process parameters µ and σ. (b) If the specifications are at 705 ± 15, and the process output is normally distributed, estimate ...In 1879, A.A. Michelson measured the velocity of light in air using a modification of a method proposed by the French physicist Foucault. Twenty of these measurements are in table 6E.27 (the value reported is in kilometers ...Reconsider the polymer viscosity data in Exercise 6.63. Use the median of the span-two moving ranges to estimate σ and set up the individuals control chart. Compare this chart to the one originally constructed using the ...The data shown in Table 6E.4 are the deviations from nominal diameter for holes drilled din a carbon-fiber composite material used in aerospace manufacturing. The values reported are deviations from nominal in ...A process is controlled with a fraction nonconforming control chart with three-sigma limits, n = 100, UCL = 0.161, center line = 0.080, and LCL = 0. (a) Find the equivalent control chart for the number nonconforming. (b) Use ...Post your question