# Question: Consider the Minitab output below a Fill in the missing values

Consider the Minitab output below.

(a) Fill in the missing values. What conclusions would you draw?

(b) Is this a one-sided or two-sided test?

(c) Use the output and a normal table to find a 95% CI on the mean.

(d) How was the SE mean calculated?

(e) What is the P-value if the alternative hypothesis is H1: > 30?

(a) Fill in the missing values. What conclusions would you draw?

(b) Is this a one-sided or two-sided test?

(c) Use the output and a normal table to find a 95% CI on the mean.

(d) How was the SE mean calculated?

(e) What is the P-value if the alternative hypothesis is H1: > 30?

**View Solution:**## Answer to relevant Questions

Suppose that you are testing H0 : 1 2 versus H1 : 1 2 with a n1 = n2 = 15. Use the table of the t distribution percentage points to find lower and upper bounds on the P-value for the following observed ...Consider the Minitab output below. (a) Fill in the missing values. (b) Is this a one-sided or two-sided test? (c) What is the P-value if the alternative hypothesis is H1: p1 = p2 versus H0: p1 > p2? (d) Construct an ...A molding process uses a five-cavity mold for a part used in an automotive assembly. The wall thickness of the part is the critical quality characteristic. It has been suggested to use X and R charts to monitor this process, ...Apply the Western Electric rules to the control chart presented in Exercise 5.19. Would these rules result in any out-of-control signals? What is meant by a process that is in a state of statistical control?Post your question