Consider the package weight data in Exercise 5.45. Suppose there is a lower specification at 0.985 kg. Calculate an appropriate process capability ratio for this material. What percentage of the packages produced by this process is estimated to be below the specification limit?
Answer to relevant QuestionsThe height of the disk used in a computer disk drive assembly is a critical quality characteristic. Table 5E.15 gives the heights (in mm) of 25 disks randomly selected from the manufacturing process. Prepare a normal ...Discuss the logic underlying the use of three-sigma limits on Shewhart control charts. How will the chart respond if narrower limits are chosen? How will it respond if wider limits are chosen? In exercise The number of nonconforming switches in samples of size 150 is shown in Table 6E.2. Construct a fraction nonconforming control chart for these data. Does the process appear to be in control? If not, assume that assignable ...Suggest at least two nonmanufacturing scenarios in which attributes control charts could be useful for process monitoring.
Post your question