# Question

Consider the situation described in Exercise 7.70. (c) = 0.533c

(a) Find two-sigma control limits and compare these with the control limits found in art (a) of exercise 7.70.

b) Find the a-risk for the control chart with two-sigma control limits and compare with the results of part (b) of Exercise 7.70.

(c) Find the β-risk for c – 2.0 for the chart with two-sigma control limits and compare with the results of part (c) of Exercise 7.70.

(d) Find the ARL if c = 2.0 and compare with the ARL found in part (d) of Exercise 7.70.

(a) Find two-sigma control limits and compare these with the control limits found in art (a) of exercise 7.70.

b) Find the a-risk for the control chart with two-sigma control limits and compare with the results of part (b) of Exercise 7.70.

(c) Find the β-risk for c – 2.0 for the chart with two-sigma control limits and compare with the results of part (c) of Exercise 7.70.

(d) Find the ARL if c = 2.0 and compare with the ARL found in part (d) of Exercise 7.70.

## Answer to relevant Questions

A control chart for nonconformities is to be established in conjunction with final inspection of a radio. The inspection unit is to be a group of ten radios. The average number of nonconformities per radio had, in the past, ...What practical difficulties could be encountered in monitoring time-between-events data? Consider the two processes shown in Table 8E.1 (the sample size n = 5). Specifications are at 100 ± 10. Calculate Cp, Cpk, and Cpm and interpret these ratios. Which process would you prefer to use? A company has been asked by an important customer to demonstrate that its process capability ratio Cp exceeds 1.33. It has taken a sample of 50 parts and obtained the point estimate Cp = 152. Assume that the quality ...Ten parts are measured three times by the same operator in a gauge capability study. The data are shown in Table 8E.9 (a) Describe the measurement error that results from the use of this gauge. (b) Estimate the total ...Post your question

0