# Question: Control charts on x and R for samples of size

Control charts on x and R for samples of size n- 5 are to be maintained on the tensile strength in pounds of a yarn. To start the charts, 30 samples were selected, and the mean and range of each computed. This yields

(a) Compute the center line and control limits for the x and R control charts.

(b) Suppose both charts exhibit control. There is a single lower specification limit of 16 lb. If strength is normally distributed, what fraction of yarn would fail to meet specifications?

(a) Compute the center line and control limits for the x and R control charts.

(b) Suppose both charts exhibit control. There is a single lower specification limit of 16 lb. If strength is normally distributed, what fraction of yarn would fail to meet specifications?

**View Solution:**## Answer to relevant Questions

Specifications on a cigar lighter detent are 0.3220 and 0.3200 in. Samples of size 5 are taken every 45 minutes with the results shown in Table 6E.18 (measured as deviations from 0.3210 in 0.0001 in.). (a) Set up an R chart ...An chart on a normally distributed quality characteristic is to be established with the standard values µ= 100, σ = 8, and n = 4. Find the following: (a) The two-sigma control limits. (b) The 0.005 probability limits. Thirty samples each of size 7 have been collected to establish control over a process. The following data were collected: (a) Calculate trial control limits for the two charts. (b) On the assumption that the R chart is in ...The following x and s charts based on n = 4 have shown statistical control: (a) Estimate the process parameters µ and σ. (b) If the specifications are at 705 ± 15, and the process output is normally distributed, estimate ...The purity of a chemical product is measured on each batch. Purity determination for 20 successive batches are shown in Table 6E.30. (a) Is purity normally distributed? (b) Is the process in statistical process control? (c) ...Post your question