# Question: Diodes used on printed circuit boards are produced in lots

Diodes used on printed circuit boards are produced in lots of size 1000. We wish to control the process producing these diodes by taking samples of size 64 from each lot. If the nominal value of the fraction nonconforming is p = 0.10, determine the parameters of the appropriate control chart. To what level must the fraction nonconforming increase to make the β-risk equal to 0.50? What is the minimum sample size that would give a positive lower control limit for this chart?

**View Solution:**## Answer to relevant Questions

A control chart for the number of nonconforming piston rings is maintained on a forging process with np = 16.0. A sample of size 100 is taken each day and analyzed. (a) What is the probability that a shift in the process ...A process is being controlled with a fraction nonconforming control chart. The process average has been shown to be 0.07. Three-sigma control limits are used, and the procedure calls for taking daily samples of 400 items. ...Consider the control chart in Exercise 7.26. Find the average run length if the process fraction nonconforming shifts to 0.20. A banking center has instituted a process improvement program to reduce and hopefully eliminate errors in their check processing operations. The current error rate is 0.01. The initial objective is to cut the current error ...Construct a standardized control chart for the data in Exercise 7.11. In Exercise 7.11Post your question