# Question: Find the power required to drive a 40 mm power screw

Find the power required to drive a 40-mm power screw having double square threads with a pitch of 6 mm. The nut is to move at a velocity of 48 mm/s and move a load of F = 10 kN. The frictional coefficients are 0.10 for the threads and 0.15 for the collar. The frictional diameter of the collar is 60 mm.

**View Solution:**## Answer to relevant Questions

A single square-thread power screw has an input power of 3 kW at a speed of 1 rev/s. The screw has a diameter of 36 mm and a pitch of 6 mm. The frictional coefficients are 0.14 for the threads and 0.09 for the collar, with a ...A ¾ in-16 UNF series SAE grade 5 bolt has a ¾ -in ID tube 13 in long, clamped between washer faces of bolt and nut by turning the nut snug and adding one-third of a turn. The tube OD is the washer-face diameter dw = 1.5d = ...We wish to alter the figure for Prob. 8–22 by decreasing the inside diameter of the seal to the diameter A = 100 mm. This makes an effective sealing diameter of 120 mm. Then, by using cap screws instead of bolts, the bolt ...If the pressure in Prob. 8–20 is cycling between 0 and 6 MPa, determine the fatigue factor of safety using the: (a) Goodman criterion. (b) Gerber criterion. (c) ASME-elliptic criterion.The bolted connection shown in the figure uses SAE grade 5 bolts. The members are hot-rolled AISI 1018 steel. A tensile shear load F = 4000 lbf is applied to the connection. Find the factor of safety for all possible modes ...Post your question