# Question: For the system shown in Fig 8 48 m1 8 0

For the system shown in Fig. 8.48, m1 = 8.0 kg, m2 = 3.0 kg, θ = 30o, and the radius and mass of the pulley are 0.10 m and 0.10 kg, respectively.

(a) What is the acceleration of the masses? (Neglect friction and the string’s mass.)

(b) If the pulley has a constant frictional torque of 0.050 m ∙ N when the system is in motion, what is the acceleration of the masses?

(a) What is the acceleration of the masses? (Neglect friction and the string’s mass.)

(b) If the pulley has a constant frictional torque of 0.050 m ∙ N when the system is in motion, what is the acceleration of the masses?

**View Solution:**## Answer to relevant Questions

A meterstick pivoted about a horizontal axis through the 0-cm end is held in a horizontal position and let go. (a) What is the initial tangential acceleration of the 100-cm position? Are you surprised by this result? (b) ...A constant retarding torque of 12 m ∙ N stops a rolling wheel of diameter 0.80 m in a distance of 15 m. How much work is done by the torque? Estimate the ratio of the translational kinetic energy of the Earth as it orbits the Sun to the rotational kinetic energy it has about its N– S axis. An industrial flywheel with a moment of inertia of rotates with a speed of 7500 rpm. (a) How much work is required to bring the flywheel to rest? (b) If this work is done uniformly in 1.5 min, how much power is required? A bocce ball with a diameter of 6.00 cm rolls with-out slipping on a level lawn. It has an initial angular speed of and comes to rest after 2.50 m. Assuming constant deceleration, determine (a) The magnitude of its angular ...Post your question