# Question: Given the band pass shown in fig 11PFE 4

Given the band-pass shown in fig 11PFE-4, find the components L and R necessary to provide a resonant frequency of 1000 r/s and a BW of 100 r/s.

**View Solution:**## Answer to relevant Questions

Given the low-pass shown in fig 11PFE-5, find the half-power frequency and the gain of this circuit, if the source frequency is 8Hz. if f(t) = t cos (ω)u (t-1) Find F (s)A single-threaded 25-mm power screw is 25 mm in diameter with a pitch of 5 mm. A vertical load on the screw reaches a maximum of 6 kN. The coefficients of friction are 0.05 for the collar and 0.08 for the threads. The ...A bolted joint is to have a grip consisting of two 14-mm steel plates and one 14R metric plain washer to fit under the head of the M14 ?2 hex-head bolt, 50 mm long. (a) What is the length of the thread LT for this diameter ...Figure P8–20 illustrates the connection of a cylinder head to a pressure vessel using 10 bolts and a confined-gasket seal. The effective sealing diameter is 150 mm. Other dimensions are: A = 100, B = 200, C = 300, D = 20, ...Post your question