Question: If a T1 carrier system slips
If a T1 carrier system slips and loses track of where it is, it tries to resynchronize using the 1st bit in each frame. How many frames will have to be inspected on average to resynchronize with a probability of 0.001 of being wrong?
Answer to relevant QuestionsWhat is the difference, if any, between the demodulator part of a modem and the coder part of a codec? (After all, both convert analog signals to digital ones.)To accommodate lower data rates than STS-1, SONET has a system of virtual tributaries (VT). A VT is a partial payload that can be inserted into an STS-1 frame and combined with other partial payloads to fill the data frame. ...The actual layout of cells is seldom as regular that as shown in Fig. 2-41. Even the shapes of individual cells are typically irregular. Give a possible reason why this might be.A CDMA receiver gets the following chips: (-1 +1 -3 +1 -1 -3 +1 +1). Assuming the chip sequences defined in Fig. 2-45(b), which stations transmitted, and which bits did each one send?One of your classmates, Scrooge, has pointed out that it is wasteful to end each frame with a flag byte and then begin the next one with a second flag byte. One flag byte could do the job as well, and a byte saved is a byte ...
Post your question