In the circuit shown, find the voltage across the current source and the power absorbed by the resistor.
Answer to relevant QuestionsA 20◦ full-depth steel spur pinion rotates at 1145 rev/min. It has a module of 6 mm, a face width of 75 mm, and 16 milled teeth. The ultimate tensile strength at the involute is 900 MPa exhibiting a Brinell hardness of ...Repeat Prob. 14–19 using helical gears each with a 20◦ normal pitch angle and a helix angle of 30◦ and a normal diametral pitch of 6 teeth/in.The gearset of Prob. 14–24 needs improvement of wear capacity. Toward this end the gears are nitrided so that the grade 1 materials have hardnesses as follows: The pinion core is 250 and the pinion case hardness is 390 ...Spur-gear teeth have rolling and slipping contact (often about 8 percent slip). Spur gears tested to wear failure are reported at 108 cycles as Buckingham’s surface fatigue load-stress factor K. This factor is related to ...Find Ix, Iy and Iz in the network shown
Post your question