Question: A joint has the same geometry as Ex 8 4
A joint has the same geometry as Ex. 8–4, but the lower member is steel. Use Eq. (8–23) to find the spring rate of the members in the grip. Hint: Equation (8–23) applies to the stiffness of two sections of a joint of one material. If each section has the same thickness, then what is the stiffness of one of the sections?
Answer to relevant QuestionsThe figure illustrates the connection of a cylinder head to a pressure vessel using 10 bolts and a confined-gasket seal. The effective sealing diameter is 150 mm. Other dimensions are: A = 100, B = 200, C = 300, D = 20, and ...In addition to the data of Prob. 8–24, the dimensions of the cylinder are A = 3.5 in and an effective seal diameter of 4.25 in. The internal static pressure is 1500 psi. The outside diameter of the head is C = 8 in. The ...A 1-in-diameter hot-rolled AISI 1144 steel rod is hot-formed into an eyebolt similar to that shown in the figure for Prob. 3–74, with an inner 2-in-diameter eye. The threads are 1 in-12 UNF and are die-cut. (a) For a ...A bolted lap joint using SAE grade 5 bolts and members made of cold-drawn SAE 1040 steel is shown in the figure. Find the tensile shear load F that can be applied to this connection if the following factors of safety are ...The figure shows a welded fitting which has been tentatively designed to be bolted to a channel so as to transfer the 2500-lbf load into the channel. The channel is made of hot-rolled low carbon steel having a minimum yield ...
Post your question