# Question

Show that for zero collar friction the efficiency of a square-thread screw is given by the equation. Plot a curve of the efficiency for lead angles up to 45◦ . Use f = 0.08.

## Answer to relevant Questions

A single-threaded 25-mm power screw is 25 mm in diameter with a pitch of 5 mm. A vertical load on the screw reaches a maximum of 6 kN. The coefficients of friction are 0.05 for the collar and 0.08 for the threads. The ...Find the power required to drive a 40-mm power screw having double square threads with a pitch of 6 mm. The nut is to move at a velocity of 48 mm/s and move a load of F = 10 kN. The frictional coefficients are 0.10 for the ...From your experience with Prob. 8–15, generalize your solution to develop a turn-of-nut equation Where Nt = turn of the nut from snug tight θ = turn of the nut in degrees N = number of thread/in (1/p where p ...The same as Prob. 8–24, except that ½ -in cap screws are used with washers (see Fig. 8–21).The section of the sealed joint shown in the figure is loaded by a repeated force P = 6 kip. The members have E = 16 Mpsi. All bolts have been carefully preloaded to Fi = 25 kip eachPost your question

0