# Question: A simply supported beam loaded by two forces

A simply supported beam loaded by two forces is shown in the figure. Select a pair of structural steel channels mounted back to back to support the loads in such a way that the deflection at midspan will not exceed 1/16 in and the maximum stress will not exceed 6 kpsi. Use superposition.

**View Solution:**## Answer to relevant Questions

Using superposition, find the deflection of the steel shaft at A in the figure. Find the deflection at midspan. By what percentage do these two values differ?Illustrated is a rectangular steel bar with simple supports at the ends and loaded by a force F at the middle; the bar is to act as a spring. The ratio of the width to the thickness is to be about b = 16h, and the desired ...For the shaft shown in the figure, let a1 = 4 in, b1 = 12 in, a2 = 10 in, F1 = 100 lbf, F2 = 300 lbf, and E = 30 Mpsi. The shaft is to be sized so that the maximum slope at either bearing A or bearing B does not exceed 0.001 ...Prove that for a uniform-cross-section beam with simple supports at the ends loaded by a single concentrated load, the location of the maximum deflection will never be outside the range of 0.423l ≤ x ≤ 0.577l ...Given the network shown, find the possible range of values for the current and power dissipated by the following resistors: a) 390 ohms with a tolerance of 1%. b) 560 ohms with a tolerance of 2%.Post your question