Answer the following questions.

1. What style of knurling is specified?

2. What type of section view is section A-A?

3. What type of view is view B?

4. What type of section was drawn to expose the threads?

5. What method of representation was used to illustrate the thread in the ϕ750 hole?

6. What method of representation was used to illustrate the thread in the ϕ 625 hole?

7. What was the former length of the knurled portion?

8. Was the chamfer (a) increased or (b) decreased by revision A/3?

9. What does the heavy line underneath the revised dimension figures designate?

10. What is the OD at section A-A?

11. What is the MMC of the 1.5000-1.5015 counterbore diameter?

12. What is the MMC of the OD at the right end?

13. What is the neck diameter if the large end of the taper measures ϕ 1.750?

14. What is the groove diameter at the small end of the taper?

15. What is the small diameter of the taper (calculate)?

16. What thread series is specified?

17. How many threads will each ϕ.750 hole contain?

18. What is the decimal pitch of the ϕ.625 thread (three decimal places)?

19. What is the tap drill diameter for the ϕ.625 threads?

20. How many threads will the ϕ.625 tapped hole contain?

Answer rating: 100% (QA)

1 The specified style of knurling is diamond by using the diamond spheroconical penetrator 2 The type of section view for section AA is removed sectio... View the full answer