A U-shaped tube is filled with water as shown. A. Rank the pressures at points A...
Fantastic news! We've Found the answer you've been seeking!
Question:
Transcribed Image Text:
A U-shaped tube is filled with water as shown. A. Rank the pressures at points A through F. Explain. Is your ranking consistent with the equation P = P, + pgh? Explain. B. The right end of the tube is now sealed with a stopper. The water levels on both sides remain the same. There is no air between the stopper and the water surface. 1. Does the pressure at points A and D increase, decrease, or remain the same? Explain. B. 2. Is the pressure at point E greater than, less than, or equal to the pressure at point D? Does the difference in pressure APg between points D and E change when the stopper is added? Explain. 3. Is the pressure at point F greater than, less than, or equal to atmospheric pressure? Is the force exerted by the rubber stopper on the water surface on the right greater than, less than, or equal to the force exerted by the atmosphere on the water surface on the left? B. C. A syringe is used to remove some water from the left side of the U-tube. The water level on the left side is seen to be lowered, but the water level on the right does not change. Consider the following student dialogue: Student 1: "The pressure at point F must now be higher than atmospheric pressure because the water there is being pushed up against the stopper." Student 2: " think that the pressure at point E must be the same as at point A because they are at the same level. These points are both at atmospheric pressure. So the pressure at point Fis lower than atmospheric pressure because we know that pressure gets less as you go up." B. Student 3: "But water is more dense than air so the pressure at F cannot be less than atmospheric pressure." *D With which student(s), if any, do you agree? A U-shaped tube is filled with water as shown. A. Rank the pressures at points A through F. Explain. Is your ranking consistent with the equation P = P, + pgh? Explain. B. The right end of the tube is now sealed with a stopper. The water levels on both sides remain the same. There is no air between the stopper and the water surface. 1. Does the pressure at points A and D increase, decrease, or remain the same? Explain. B. 2. Is the pressure at point E greater than, less than, or equal to the pressure at point D? Does the difference in pressure APg between points D and E change when the stopper is added? Explain. 3. Is the pressure at point F greater than, less than, or equal to atmospheric pressure? Is the force exerted by the rubber stopper on the water surface on the right greater than, less than, or equal to the force exerted by the atmosphere on the water surface on the left? B. C. A syringe is used to remove some water from the left side of the U-tube. The water level on the left side is seen to be lowered, but the water level on the right does not change. Consider the following student dialogue: Student 1: "The pressure at point F must now be higher than atmospheric pressure because the water there is being pushed up against the stopper." Student 2: " think that the pressure at point E must be the same as at point A because they are at the same level. These points are both at atmospheric pressure. So the pressure at point Fis lower than atmospheric pressure because we know that pressure gets less as you go up." B. Student 3: "But water is more dense than air so the pressure at F cannot be less than atmospheric pressure." *D With which student(s), if any, do you agree?
Expert Answer:
Answer rating: 100% (QA)
Solution A P F P A P B P C and P A P E and P C P D Pressure increases as the elevation decreases or ... View the full answer
Related Book For
Fundamentals of Momentum, Heat and Mass Transfer
ISBN: 978-1118947463
6th edition
Authors: James Welty, Gregory L. Rorrer, David G. Foster
Posted Date:
Students also viewed these mechanical engineering questions
-
A mass-transfer process is used to remove ammonia (NH 3 , solute A) from a mixture of NH 3 and air, using water as the absorption solvent. At the present conditions of operation, the partial pressure...
-
A packed tower is used to remove component A from a gas stream mixture containing 12.0 mole% A and 88.0 mole% inerts. The gas mixture is fed to the bottom of the tower, and the desired superficial...
-
Calcium oxide (CaO) is used to remove sulfur dioxide generated by coal-burning power stations: Calculate the enthalpy change for this process if 6.6 ( 105 g of SO2 are removed by this process every...
-
Consider a random walk consisting of equi-probable p = q = 1/2 steps in left or right directions. However the step length at ith step is given by e-, i = 1,2,3..... N, with > 0 a constant. Calculate...
-
Does an intangible asset have a finite or indefinite life? Explain.
-
Describe the main factors economists believe cause inequality of income.
-
How does an auditor verify recorded shareholders' equity balances?
-
That old equipment for producing subassemblies is worn out, said Paul Taylor, president of Timkin Company. We need to make a decision quickly. The company is trying to decide whether it should rent...
-
Suppose f(x) and f'(x) are continuous but restricted to the interval 0 < x < 20, and assume the values of f'(x) are as shown. For each value, determine whether there is a local maximum, local...
-
Question 1 According to a distribution network optimization conducted 5 years ago, all the demand of AL, GA, KY, SC, and TN is shipped from the warehouse located in Atlanta, GA. The warehouse in...
-
Josh and Janie run a shuttle service from Water Tower Place to Chicago O'Hare airport. Last month, they recorded the following: Revenues [25 trips @ $80 per trip] $ 2000 Fuel charge [25 trips @$30...
-
3. In Japan, some road curves are marked with their radius of curvature, in addition to the speed limit of that curve. For instance, a sign will indicate a curve whose speed limit is 88. km/hr and a...
-
Solar energy conversion device: 1. Research the engineering design process and draw a flowchart of the process. Use flowchart to develop a plan to design an engineering solution for the problem you...
-
John is represented by Attorney Monty Stratton. With their attorneys' guidance and advice, the parties continue to negotiate to reach a complete Marital Settlement Agreement. They have reached an...
-
Basic Facts: Robert Sellar is the owner of a house and lot in the residential area of Smalltown. On March 15, Sellar and Bonnie Byer entered into a written agreement by the terms of which Sellar...
-
Vinnie's, a small neighborhood bar, has been a favorite of locals for years. One afternoon in March, Bert, a regular customer at Vinnie's, overhears Vinnie on the phone behind the bar making a series...
-
Please find the price of the following bond: $1,000 face value. 6% semi-annual coupon, 5.5% market rates, and 8 years to maturity.
-
Suppose you are comparing just two means. Among the possible statistics you could use is the difference in means, the MAD, or the max min (the difference between the largest mean and the smallest...
-
An industrial heater is composed of a tube bundle consisting of horizontal 3/8-in.-OD tubes in a staggered array with tubes arranged in equilateral triangle fashion having a pitch to-diameter ratio...
-
Air at 60F and atmospheric pressure flows inside a 1-in., 16-BWG copper tube whose surface is maintained at 240F by condensing steam. Find the temperature of the air after passing through 20 ft of...
-
Derive the equation of motion for a one-dimensional, inviscid, unsteady compressible flow in a pipe of constant cross sectional area neglect gravity.
-
The marginal density function of \(x\) can be determined form the bivariate density function \(p(x, y)\) as a. \(p(x)=\int_{-\infty}^{\infty} p(x, y) d y\) b. \(p(x)=\int_{-\infty}^{\infty} p(x, y) d...
-
Compute the autocorrelation function of a periodic square wave with zero mean value and compare this result with that of a sinusoidal wave of the same period. Assume the amplitudes to be the same for...
-
The correlation coefficient of \(x\) and \(y\) is given by a. \(\sigma_{x y}\) b. \(\sigma_{x y} /\left(\sigma_{x} \sigma_{y} ight)\) c. \(\sigma_{x} \sigma_{y}\)
Study smarter with the SolutionInn App