Image transcription text

Problem 1: Make a part in SolidWorks from the given drawing sheet below. All dimensions are in inches. All sketches must be fully
defined. (25 points) 0 1.00 1.50 300 200 = 1.50 3.00 3100 200 300 = 100

Problem 1: Make a part in SolidWorks from the given drawing sheet below. All dimensions are in inches. All sketches must be fully defined. (25 points)

 0 1.00 

1.50 

300 

200 

= 1.50

 3.00 

3100 

200 

300 

1.OO

 = 100

Additional comments: The shaded contour only works for the entire shape from the top view, everytime I have fully defined the shape there is no region shaded for the contour. So if I extrude it just brings the entire shape from the top view up. 

Transcribed Image Text:

Problem 1: Make a part in SolidWorks from the given drawing sheet below. All dimensions are in inches. All sketches must be fully defined. (25 points) 3.00 01.00 1.50 2.00 1.00 2.00- 6.00 1.50 -3.00 $1.00 2.50 4.00 3.00 1.00 200 Problem 1: Make a part in SolidWorks from the given drawing sheet below. All dimensions are in inches. All sketches must be fully defined. (25 points) 3.00 01.00 1.50 2.00 1.00 2.00- 6.00 1.50 -3.00 $1.00 2.50 4.00 3.00 1.00 200