Use the information below to correctly connect and configure the devices in the existing topology. All...

Transcribed Image Text:

Use the information below to correctly connect and configure the devices in the existing topology. All specified values must be entered exactly and is case-sensitive. Choose values for those not specified. No results or feedback will be shown. Verify configurations manually and by connectivity tests. You will not configure CISCOLAB-SWITCH. Intermediary devices must be configured using a console connection. SUBNETTING Use the subnetting table and listed requirements to determine and configure IPv4 addressing. Subnetting Table Subnet Network Number Address 1 2 3 4 5 6 192.168.1.0 Broadcast Address Mask Assignment CISCOLAB-LAN Subnet CYBERLAB-LAN Subnet Subnetting Requirements 1. Subnets 1-4: Subnet 192.168.1.0/24 by allowing for 30 hosts per subnet. 2. Assign Subnet 4 to the CISCOLAB-LAN. 3. 4. 5. Subnet 5-6: Subnet again allowing for 14 host addresses per subnet. Assign Subnet 6 to CYBERLAB-LAN. Configure addresses on the hosts using any of the remaining addresses in their respective subnets. Use the information below to correctly connect and configure the devices in the existing topology. All specified values must be entered exactly and is case-sensitive. Choose values for those not specified. No results or feedback will be shown. Verify configurations manually and by connectivity tests. You will not configure CISCOLAB-SWITCH. Intermediary devices must be configured using a console connection. SUBNETTING Use the subnetting table and listed requirements to determine and configure IPv4 addressing. Subnetting Table Subnet Network Number Address 1 2 3 4 5 6 192.168.1.0 Broadcast Address Mask Assignment CISCOLAB-LAN Subnet CYBERLAB-LAN Subnet Subnetting Requirements 1. Subnets 1-4: Subnet 192.168.1.0/24 by allowing for 30 hosts per subnet. 2. Assign Subnet 4 to the CISCOLAB-LAN. 3. 4. 5. Subnet 5-6: Subnet again allowing for 14 host addresses per subnet. Assign Subnet 6 to CYBERLAB-LAN. Configure addresses on the hosts using any of the remaining addresses in their respective subnets.