# Question: Suppose that 20 of the parts manufactured by the processes

Suppose that 20 of the parts manufactured by the processes in Exercise 8.11 were assembled so that their dimensions were additive; that is, x x1 x2 Specifications on x are 2,000 200. Would you prefer to produce the parts using process A or process B? Why? Do the capability ratios computed in Exercise 8.11 provide any guidance for process selection?

## Relevant Questions

The weights of nominal 1-kg containers of a concentrated chemical ingredient are shown in Table 8E.2. Prepare a normal probability plot of the data and estimate process capability. Does this conclusion depend on process ...A normally distributed process has specifications of LSL = 75 and USL = 85 on the output. A random sample of 25 parts indicates that the process is centered at the middle of the specification band, and the standard deviation ...An operator-instrument combination is known to test parts with an average error of zero; however, the standard deviation of measurement error is estimated to be 3. Samples from a controleld process were analyzed, and the ...Three parts are assembled in series so that their critical dimensions x1, x2, and x3 add. The dimensions of each part are normally distributed with the following parameters: 1 100,1 4, 2 75, 2 4, ...We wish to estimate a two-sided natural tolerance interval that will include 99% of the values of a random variable with probability 0.80. If nothing is known about the distribution of the random variable, how large should ...Post your question