# Question: Ten parts are measured three times by the same operator

Ten parts are measured three times by the same operator in a gauge capability study. The data are shown in Table 8E.9

(a) Describe the measurement error that results from the use of this gauge.

(b) Estimate the total variability and product variability.

(c) What percentage of total variability is due to the gauge?

(d) If specifications on the part are at 100 ± 15, find the P/T ratio for this gauge. Comment on the adequacy of the gauge.

(a) Describe the measurement error that results from the use of this gauge.

(b) Estimate the total variability and product variability.

(c) What percentage of total variability is due to the gauge?

(d) If specifications on the part are at 100 ± 15, find the P/T ratio for this gauge. Comment on the adequacy of the gauge.

**View Solution:**## Answer to relevant Questions

In a study to isolate both gauge repeatability and gauge reproducibility, two operators use the same gauge to measure ten parts three times each. The data are shown in Table 8E.10. (a) Estimate gauge repeatability and ...Two parts are assembled as shown in the figure. The distributions of x1 and x2 are normal, with 1 20,1 0.32 19.6, 2 0.4 . The specifications of the clearance between the mating parts are 0.5 ...An assembly of two parts is formed by fitting a shaft into a bearing. It is known that the inside diameters of bearings are normally distributed with mean 2.010 cm and standard deviation 0.002 cm, and that the outside ...Find the sample size required to construct an upper nonparametric tolerance limit that contains at least 95% of the population with probability at least 0.95. How would this limit actually be computed from sample data? Consider the hospital emergency room waiting time data in Exercise 8.16. Set up a CUSUM chart for monitoring this process. Does the process seem to be in statistical control? x p50 4.55; p84 7.34; p84 ...Post your question