# Question: The C clamp shown in the figure for Prob 8 7

The C clamp shown in the figure for Prob. 8–7 uses a 5/8 in-6 Acme thread. The frictional coefficients are 0.15 for the threads and for the collar. The collar, which in this case is the anvil striker’s swivel joint, has a friction diameter of 7/16 in. Calculations are to be based on a maximum force of 6 lbf applied to the handle at a radius of 2 ¾ in from the screw centerline. Find the clamping force.

**View Solution:**## Answer to relevant Questions

Find the power required to drive a 40-mm power screw having double square threads with a pitch of 6 mm. The nut is to move at a velocity of 48 mm/s and move a load of F = 10 kN. The frictional coefficients are 0.10 for the ...A blanking disk is 20 mm thick and is to be fastened to a spool whose flange is 25 mm thick, using eight M12 ?40 hex-head metric cap screws. (a) What is the length of the threads LT for this fastener? (b) What is the ...Figure P8–20 illustrates the connection of a cylinder head to a pressure vessel using 10 bolts and a confined-gasket seal. The effective sealing diameter is 150 mm. Other dimensions are: A = 100, B = 200, C = 300, D = 20, ...The upside-down steel A frame shown in the figure is to be bolted to steel beams on the ceiling of a machine room using ISO grade 8.8 bolts. This frame is to support the 40-kN radial load as illustrated. The total bolt grip ...The figure shows a bolted lap joint that uses SAE grade 8 bolts. The members are made of cold-drawn AISI 1040 steel. Find the safe tensile shear load F that can be applied to this connection if the following factors of ...Post your question