Question: The crane hook depicted in Fig 3 35 has a 1 in diameter
The crane hook depicted in Fig. 3–35 has a 1-in-diameter hole in the center of the critical section. For a load of 5 kip, estimate the bending stresses at the inner and outer surfaces at the critical section.
Answer to relevant QuestionsA 20-kip load is carried by the crane hook shown in the figure. The cross section of the hook uses two concave flanks. The width of the cross section is given by b = 2/r, where r is the radius from the center. The inside ...An aluminum alloy roller with diameter 1 in and length 2 in rolls on the inside of a cast-iron ring having an inside radius of 4 in, which is 2 in thick. Find the maximum contact force F that can be used if the shear stress ...A bar in tension has a circular cross section and includes a conical portion of length l , as Shown, the task is to find the spring rate of the entire bar. Equation (4–4) is useful for the outer portions of diameters d1 ...A simply supported beam loaded by two forces is shown in the figure. Select a pair of structural steel channels mounted back to back to support the loads in such a way that the deflection at midspan will not exceed 1/16 in ...The structure of a diesel-electric locomotive is essentially a composite beam supporting a deck. Above the deck are mounted the diesel prime mover, generator or alternator, radiators, switch gear, and auxiliaries. Beneath ...
Post your question