# Question: The data in Table 6E 17 were collected form a process

The data in Table 6E.17 were collected form a process manufacturing power supplies. The variable of interest is output voltage, and n = 5.

(a) Compute center lines and control limits suitable for controlling future production.

(b) Assume that the quality characteristic is normally distributed. Estimate the process standard deviation.

(c) What are the apparent three-sigma natural tolerance limits of the process?

(d) What would be your estimate of the process fraction nonconforming if the specifications on the characteristic were 103+ – 4?

(e) What approaches to reducing the fraction nonconforming can you suggest?

(a) Compute center lines and control limits suitable for controlling future production.

(b) Assume that the quality characteristic is normally distributed. Estimate the process standard deviation.

(c) What are the apparent three-sigma natural tolerance limits of the process?

(d) What would be your estimate of the process fraction nonconforming if the specifications on the characteristic were 103+ – 4?

(e) What approaches to reducing the fraction nonconforming can you suggest?

**View Solution:**## Answer to relevant Questions

Control charts on x and R for samples of size n- 5 are to be maintained on the tensile strength in pounds of a yarn. To start the charts, 30 samples were selected, and the mean and range of each computed. This yields (a) ...Control charts for and s are maintained on a quality characteristic. The sample size is n = 4. After 30 samples, we obtain (a) Find the three-sigma limits for the s chart. (b) Assuming that both charts exhibit control, ...Specifications on a normally distributed dimension are 600 ± 20. x and R charts are maintained on this dimension and have been in control over a long period of time. The parameters of these control charts are as follows (n ...Components used in a cellular telephone are manufactured with nominal dimension of 0.3 mm and lower and upper specification limits of 0.295 mm and 0.305 mm respectively. The x and R control charts for this process are based ...The uniformity of a silicon wafer following an etching process is determined by measuring the layer thickness at several locations and expressing uniformity as the range of the thicknesses. Table 6E.29 presents uniformity ...Post your question