# Question: The data in Table 9E 3 are temperature readings from a

The data in Table 9E.3 are temperature readings from a chemical process in C, taken every two minutes. (Read the observations down, from left.) The target value for the mean is 0 = 950.

(a) Estimate the process standard deviation.

(b) Set up and apply a tabular CUSUM for this process, using standardized values h= 5 and k = ½. Interpret this chart.

(a) Estimate the process standard deviation.

(b) Set up and apply a tabular CUSUM for this process, using standardized values h= 5 and k = ½. Interpret this chart.

**View Solution:**## Answer to relevant Questions

Bath concentrations are measured hourly in a chemical process. Data (in ppm) for the last 32 hours are shown in Table 9E.4 (read down from left). The process target is µ0 = 175 ppm. (a) Estimate the process standard ...Specifications on a bearing diameter are established at 8.0 ± 0.01 cm. Samples of size n = 8 are used, and a control chart for s shows statistical control, with the best current estimate of the population standard deviation ...Set up a moving center-line EWMA control chart for the molecular weight data in Exercise 10.16. Compare it to the residual control chart in Exercise 10.16, part (c). To find the optimal , fit an ARIMA (0,1,1) (= EWMA = ...Consider the temperature data in exercise 10.24. Set up an EWMA control chart on the residuals from the model you fit to the data in part (c) of that exercise. Compare it to the individuals chart you constructed using the ...A sample of five units of product is taken from a production process every hour. The results in Table 10E.12 are obtained. Assume that the specifications on this quality characteristic are at 1.0015 and 1.0035. Set up the R ...Post your question