# Question: The data shown in Table 6E 4 are the deviations from

The data shown in Table 6E.4 are the deviations from nominal diameter for holes drilled din a carbon-fiber composite material used in aerospace manufacturing. The values reported are deviations from nominal in ten-thousandths of an inch.

(a) Set up x and R charts on the process. Is the process in statistical control?

(b) Estimate the process standard deviation using the range method.

(c) If specifications are at nominal 100, what can you say about the capability of this process? Calculate the PCR Cp.

(a) Set up x and R charts on the process. Is the process in statistical control?

(b) Estimate the process standard deviation using the range method.

(c) If specifications are at nominal 100, what can you say about the capability of this process? Calculate the PCR Cp.

**View Solution:**## Answer to relevant Questions

A financial services company monitors loan applications. Every day 50 applications are assessed for the accuracy of the information on the form. Results for 20 days are where Di is the number of loans on the ith day that re ...A control chart for the number of nonconforming piston rings is maintained on a forging process with np = 16.0. A sample of size 100 is taken each day and analyzed. (a) What is the probability that a shift in the process ...A control chart is used to control the fraction nonconforming for a plastic part manufactured in an injection molding process. Ten subgroups yield the data in Table 7E.9. (a) Set up a control chart for the number ...Construct a standardized control chart for the data in Exercise 7.29. In Exercise 7.29 A fraction nonconforming control chart with n = 400 has the following parameters: UCL = 0.0962; Center line = 0.0500; LCL = 0.0038. (a) Find the width of the control limits in standard deviation units. (b) Suppose the ...Post your question