The diameter of a metal rod is measured by 12 inspectors, each using both a micrometer caliper and a vernier caliper. The results are shown in Table 4E.3. Is there a difference between the mean measurements produced by the two types of caliper? Use = 0.01.
Answer to relevant QuestionsThe cooling system in a nuclear submarine consists of an assembly pipe through which a coolant is circulated. Specifications require that weld strength must meet or exceed 150 psi. (a) Suppose the designers decide to test ...Suppose we are testing the hypotheses H0 : 1 2 H1 : 1 2 where 12 and 22 are known. Resources are limited, and consequently the total sample size n1 + n2 = N. How should we allocate the N ...Compare the mean compressive strength at each rodding level from Exercise 4.37 with a scaled t distribution. What conclusions would you draw from this plot? Plot the residuals from Problem 4.44 and comment on model adequacy. Suppose that you are testing H0 : 1 2 versus H1 : 1 2 with a n1 = n2 = 15. Use the table of the t distribution percentage points to find lower and upper bounds on the P-value for the following observed ...
Post your question