The drain plug on a car’s engine has been tightened to a torque of 25 m ∙ N. If a 0.15-m-long wrench is used to change the oil, what is the minimum force needed to loosen the plug?
Answer to relevant QuestionsIn Exercise 10, due to limited work space, you must crawl under the car. The force thus cannot be applied perpendicularly to the length of the wrench. If the applied force makes a 30o angle with the length of the wrench, ...Telephone and electrical lines are allowed to sag between poles so that the tension will not be too great when something hits or sits on the line. (a) Is it possible to have the lines perfectly horizontal? Why or why not? ...An artist wishes to construct a birds and bees mobile, as shown in Fig. 8.40. If the mass of the bee on the lower left is 0.10 kg and each vertical support string has a length of 30 cm, what are the masses of the other birds ...A force is applied to a cord wrapped around a solid 2.0-kg cylinder as shown in Fig. 8.45. Assuming the cylinder rolls without slipping, what is the force of friction acting on the cylinder? A bowling ball with a radius of 15.0 cm travels down the lane so that its center of mass is moving at 3.60 m/s. The bowler estimates that it makes about 7.50 complete revolutions in 2.00 seconds. Is it rolling with-out ...
Post your question