# Question: The figure shows a crank loaded by a force F

The figure shows a crank loaded by a force F = 190 lbf which causes twisting and bending of the ¾ -in-diameter shaft fixed to a support at the origin of the reference system. In actuality, the support may be an inertia which we wish to rotate, but for the purposes of a strength analysis we can consider this to be a static’s problem. The material of the shaft AB is hot-rolled AISI 1018 steel (Table A–20). Using the maximum-shear-stress theory, find the factor of safety based on the stress at point A.

**View Solution:**## Answer to relevant Questions

Given the summing amplifier shown, select the values of R2 that will produce an output voltage of –3v. This problem illustrates that the strength of a machine part can sometimes be measured in units other than those of force or moment. For example, the maximum speed that a flywheel can reach without yielding or fracturing is ...Repeat Prob. 5–25 using maximum-shear-stressA tube has another tube shrunk over it. The specifications are A cylinder subjected to internal pressure pi has an outer diameter of 350 mm and a 25-mm wall thickness. For the cylinder material, KI c = 80 MPa, √m, Sy = 1200 MPa, and Sut = 1350 MPa. If the cylinder contains a ...Post your question